In the first pic the evostik is spread on the hull. Pic2 the plate is positioned & strips of tape stuck to one edge. Pic3 the tape acting as a hinge, the plate is lifted. I then repeat with as many plates as I can as the evo dries. Only then is the plate laid down, the tape ensures the correct position. Evo is Impact adhesive so gently tap with a small hammer. Pic4 shows it is possible to do a cruiser stern, but it is tricky. The paddle steamer hull was flush riveted, so none shown. Method for embossing rivets next post.

Pic 1 my riveting tool. Just a block of wood with a row of panel pins. They must be the self punching type. pointed head not flat. The close ups are of scale model CROWPILL, an old coaster. 2ft long. Well weathered as can be seen. Coming up the muddy river to Bridgwater the hull became stained. To replicate this I made a pond off polythene sheet, pored thinned oil paint on the water. Dipped the model down to load line, remove then dip again to the light water line, Increasing the stain. The model Is made of polyuathen foam & the plates attached with 5 minute epoxy.