Annuaire du port

Wave Jumper

Répertorié par Graham 1954 ·

Caractéristiques

Longueur du bateau
30" (76.20 cm)
Type de moteur
Brushed
Type d’entraînement
Direct
Hélices
260
Type de batterie
LiIon
Type d’hélice
312
Taille de l’hélice
326mm
Vitesse du modèle
376 km/h (233.6mph)

Photos

Vidéo

À propos de ce bateau

This is a very old model from about 15 years ago. I have just put some old motors in and repaired loads of cracks.
Its great fun taking it out to sea in waves that are about a foot high and jump from wave to wave.
Have tried to down load video from phone but dose not seem to work ?

Commentaires

  1. Steveg171
    Quartier-maître 1re classe
    Hi again Graham,
    That's better and answers my question about the steering. Zips about quite well really.
  2. Steveg171
    Quartier-maître 1re classe
    Wow, those motors look like they have done the rounds. I like how you have set the rudder under the transom, I was thinking of sticking mine on the stern, more "outrigger" style. How does it steer with your set up ?
  3. Graham 1954
    Quartier-maître 1re classe
    Hi. Are you not able to view the vid. This is the first time I have done this so not sure if I done it correctly.

    I have changed the You tube settings
    Aimé par Steveg171
  4. Steveg171
    Quartier-maître 1re classe
    Hi, is the video private ? I have one of these I'm currently looking to get going. It's a bare hull with only shafts still in it. Looking for ideas bsfore I kick off.
  5. Graham 1954
    Quartier-maître 1re classe
    Yes my model was the same drive set up with the speed controller operating steering so added a rudder. I will take some more pics for you.
    Hope the link will work.
    Aimé par Steveg171
  6. BOATSHED
    Capitaine
    Have you got any pictures of inside her now and maybe any of before you changed her. Can you show a couple of pictures of the bottom oh the hull please? I would like some idea's and insipration on another build that I might try. I have started to convert one of those cheap R/C twin motor boats I'm not sure if it's an NQD one. I am leaving in the 380 motor's for now but putting in better R/C instead of the wierd stuff the Chinese have put in. I have repainted it and the motor's will be worked from one speed controller and a seperate rudder fitted to the stern so the motors aren't used for turning the boat. It is still in the part way of the build. I haven't chnged the small prop shaft's. I'm just doing it for a bit of fun. I do have another one I might do a better job on and put in a brushless motor.
    Aimé par Steveg171

Delete this post?

Il sera retiré du site.

Abandonner ce brouillon ?

Votre brouillon sera supprimé et ne pourra pas être récupéré.

Vous avez un brouillon inachevé

Que souhaitez‑vous en faire ?