Annuaire du port
Bad Ass and Green Streak airboat's
Caractéristiques
- Longueur du bateau
- 6" (15.24 cm)
- Poids du bateau
- 197g (7 oz)
- Type de moteur
- Brushless
- Type d’entraînement
- Direct
- Hélices
- Single
- Amp maximal
- 269A
- Type de batterie
- LiIon
- mAh de la batterie
- 284 mAh
- Type d’hélice
- 3 Blade
- Taille de l’hélice
- 348mm
- Durée d’exploitation
- 352 min
- Vitesse du modèle
- 375 km/h (233mph)
Photos
À propos de ce bateau
2 but shortly will be 20 rc airboats. I found a free stl file for a 3d printed airboat and got to work altering it with an inbuilt air tight section in the bow and a better laid out hull along with clean wire free motor and rudder installation. Everything is serviceable and removes with a couple of screws.
They have a small gyro to help them track better and are powered by 1800kv motor, 40amp esc and a 2s 1000 30c lipo.
Rubber bumper strip and the option for FPV camera
These are for a new low cost racing league for our club this year.
I say low cost as its £2.19 to print each boat. 87p for esc, £1.10 for servo, £6 motor, £7 propeller, £10 lipo! So £27.16 if you have you're own transmitter and receiver.
The optional gyro can be found for as little as £5 though i increased the depth of the strakes on the flat hull to help them track better
They have a small gyro to help them track better and are powered by 1800kv motor, 40amp esc and a 2s 1000 30c lipo.
Rubber bumper strip and the option for FPV camera
These are for a new low cost racing league for our club this year.
I say low cost as its £2.19 to print each boat. 87p for esc, £1.10 for servo, £6 motor, £7 propeller, £10 lipo! So £27.16 if you have you're own transmitter and receiver.
The optional gyro can be found for as little as £5 though i increased the depth of the strakes on the flat hull to help them track better
Aimé par
Chargement…
Commentaires
Se connecter pour commenter.
But those where never able to have R/C in them.
I would love one like yours but twice the length and maybe half as wide.
I amase at you people who 3d print things.
Like the Massive Bluebird Model that has been done.
I was surprised that yours carried on and came back to shore under it's own power
upsied down. Amazing. 👍👍