#5149

GregHiltz Canada Or

Adjudant  · 634 pts Saint John, Canada Membre depuis Sep 2018 Dernière connexion il y a 4 heures
139 Messages 8 Abonnés
0 Bateaux au port
0 Blogs de construction
374 Mentions J’aime reçues

Abonnés

8 abonnés

Téléversements récents

Dernière activité

Dernière publication il y a 3 mois
Build blog commentRe: build blogYes a good Multimeter is your best friend when gearing up or trouble-shooting any R/C or motorized equipment I have seen a simple faulty switch cause me grief for over an hour, wanting to believe it had to be …Forum replyRe: Fuse for 12 pole 12-24 volt Hi Torque Motor (as supplied by Mobile Marine Models)@Hsailer -As I mentioned, 2 to 3 second shots, just long enough to get an Amperage reading. I have been working and testing motors for over 50 years, snd have never fried one yet by testing.Forum replyRe: Fuse for 12 pole 12-24 volt Hi Torque Motor (as supplied by Mobile Marine Models)As said by another member, you need to determine the max of stall amperage draw. You did not specify if single or twin motors in your Tug, but assuming single, I suggest putting a pair Vice-Grip locking pliers…Forum replytwo motors one escIn my 50 years of gearing up and running R/C boats, I have always been cognitive of fusing my systems , as at sailings I have seen boats blow fuses out in the water, seen some burn up their motors, and others …466 viewsHarbour commentRe: Möwe - TrawlerNice, clean work especially for your first build, a bit different in the configuration of the Mast & booms for actual fishing gear.289 viewsForum replyWood gluesPersonally I would use a slow setting (30 minute) epoxy, spread thinly on the plywood, and lay as many planks down as you can in 20 minutes. Spend the remainder time holding all in place until set.422 viewsForum replytwo or oneYou do not say which type boat is is, but if it is a fast boat, probably one ESC is ok, so long as it is rated with a high enough amperage . Two Speed Controllers will give you great maneuvering, allowing you …547 viewsForum replyprop questionIf at all possible, even though the Prop may be threaded onto your shaft, Yesvyou should havevz lock nut on the shaft. If your prop is not threaded you should have a keyed 'Drive Dog collar ahead of the prop a…445 viewsForum replyHM/50 ESCPlease post photos of the ESC526 viewsBuild blog commentRe: Next project: 36 ft Northern Bay sport fishermanThis should make a great R/C boat.1,011 views

Delete this post?

Il sera retiré du site.

Abandonner ce brouillon ?

Votre brouillon sera supprimé et ne pourra pas être récupéré.

Vous avez un brouillon inachevé

Que souhaitez‑vous en faire ?